A wide variety of accessories is available to ease the installation and operation of SunTouch electric floor heating solutions. Choose among installation tools, floor heating thermostat accessories, repair kits, custom power leads, and other accessories for your floor warming system.

LoudMouth Monitor
The LoudMouth monitors electric heating wire elements during the entire installation process and sounds an alarm if the heating elements are cut or damaged.
View Support LiteratureFeatures:
- 9V battery power
- On/off switch
- Indicator lights
- Test button & audible alarm

Double-Sided Tape
This 36-yard length of extra double-sided tape works with TapeMat and CableStraps.
View Support LiteratureFeatures:
- Additional aid to secure TapeMat to the floor
- Secures CableStraps to the subfloor in WarmWire and SlabHeat installations

CableStrap
CableStrap makes it easy to install WarmWire & SlabHeat at the desired spacing. Each 25-ft roll covers approximately 40 ft2 to 50 ft2 of heated floor area.
View Support LiteratureFeatures:
- Vertical tabs are spaced 1” apart
- Horizontal tabs provide extra half inch measurement
- Thin profile

Floor Sensor
This SunStat compatible sensor provides accurate sensing of the floor temperature. The low- profile sensor is designed to be embedded in mortar.
View Support Literature
CableTrowel
CableTrowel is recommended for applying mortar over any SunTouch electric heating system. Consider using the 3/8" wide by 1/2" deep, U-shaped, notched CableTrowel for added peace of mind. Its non-metal construction helps prevent damage to wire.
View Support Literature
Heating Wire Repair Kit for Custom TapeMat, TapeMat, UnderFloor Mat & WarmWire
Used for Custom TapeMat, TapeMat, UnderFloor Mat and WarmWire systems. Before ordering, consult the factory at 888-432-8932 to make sure it is suitable for your repair. It includes materials for one repair: 2 jumper wires, 1 ground jumper wire, 2 ground solder tubes, and 4 heating wire solder tubes.
View Support LiteratureFeatures:
- Do not use for ShowerMat, SlabHeat or ProMelt systems
- Includes detailed written instructions

Heating Wire Repair Kit for SlabHeat & ProMelt
Before ordering consult the factory at 888-432-8932 to make sure it is suitable for your type of repair. The kit is used for SlabHeat systems and includes materials to make one repair: 2 jumper wires, 1 ground jumper wire, 2 ground solder tubes, 4 heating wire solder tubes, and 1 shrink sleeve.
View Support LiteratureFeatures:
- Includes detailed written instructions

Extra Long Power Leads
Contact us to order products with power leads that are longer than the standard length. We’ll attach a custom power lead to fit your application.
View Support LiteratureFeatures:
Custom TapeMat, TapeMat, ShowerMat, UnderFloor Mat & WarmWire:
- Standard lead length is 10'
- 120 VAC or 240 VAC
SlabHeat:
- Standard lead length is 20'
- 120 VAC or 240 VAC
- Consult factory to order